Customize Parameters

NOTE: The following items can be customized.

NOTE:

After confirming whether the items requested by the customer are applicable or not for customization, perform the customize operation.
Be sure to record the current settings before customizing.
When troubleshooting, make sure that the item in question is not set to "OFF" as a result of customization.

Standard (Power Back Door ECU):

POWER BACK DOOR SYSTEM CUSTOMIZE PARAMETERS

DISPLAY (ITEM)

DEFAULT

CONTENTS

SETTING

PBD SW OPER

0.8s

Function that turns power back door switch ON when switch is pushed once or held down for 0.8 sec.

0.8s/ON

PBD BUZZ VOL

OFF

Function that adjusts the volume of warning buzzer that notifies power back door is operating

OFF/SMALL/LARGE

WIRELS PBD OPER

0.8s

Function that operates power back door when transmitter switch is pressed in specified way (1-press, 2-presses, 0.8 sec.-press or OFF⁽¹⁾)

ON/TWICE ON/0.8s/OFF

PBD ASSIST CLS⁽²⁾

Function that helps power back door closing operation

ON/OFF

PBD ASSIST OPN⁽³⁾

OFF

Function that helps power back door opening operation

ON/OFF

⁽¹⁾	Wireless (transmitter switch) operation of the power slide door is disabled.

⁽²⁾	When this item is set to ON: When the back door is fully open, manually moving the back door approximately 12 cm within 0.5 sec. in the direction that the back door closes activates the power back door system to automatically close.

⁽³⁾	When this item is set to ON: When the back door is fully closed, pulling the outside handle activates the power back door system to automatically open after the back door is unlatched.