Inspection Procedure
- PERFORM ACTIVE TEST BY HAND-HELD TESTER (COMBINATION METER)
- Operate the hand-held tester according to the steps on the display and PERFORM the "ACTIVE TEST".ACTIVE TEST DETAILS
Item Test Details Diagnostic Note COOLANT TEMP LOW / NORM / HIGH -
- NG: CHECK AND REPLACE COMBINATION METER ASSY
- OK: Go to next step.
- Operate the hand-held tester according to the steps on the display and PERFORM the "ACTIVE TEST".
- READ VALUE OF HAND-HELD TESTER (COMBINATION METER)
- Operate the hand-held tester according to the steps on the display and select "DATA LIST".DATA LIST TEST DETAILS
Item Test Details Diagnostic Note COOLANT Coolant Temperature / Min.: -40°C, Max.: 140°C -
- NG: GO TO ENGINE CONTROL SYSTEM
- OK: Go to next step.
- Operate the hand-held tester according to the steps on the display and select "DATA LIST".
- CHECK THAT MALFUNCTION DISAPPEARS A KNOWN GOOD COMBINATION METER IS INSTALLED
- NG: CHECK AND REPLACE ECM
- OK: CHECK AND REPLACE COMBINATION METER ASSY