LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> RAV4 Base, AWD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Master Cylinder >> Removal & Installation

Removal & Installation

  1. Disconnect fluid level warning switch connector. Remove fluid from master cylinder with syringe.
  2. Disconnect brake lines and 3-way line connector from master cylinder. If equipped with M/T, disconnect clutch reservoir hose. On all models, remove 2 bolts and master cylinder.
  3. Prior to installation, adjust length of brake booster push rod if necessary. See POWER BRAKE UNIT PUSH ROD  under ADJUSTMENTS. If adjusting booster push rod, install new gasket before checking adjustment.
  4. Install master cylinder in reverse of removal procedure. Use NEW gasket. Fill and bleed system. Check for leaks and adjust pedal, if needed. Bleed clutch system, if equipped.
scientia non olet · About LEMON Manuals