Inspection Procedure
WARNING: This page is about a different car, the 2005 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Perform zero point calibration. (See PRE-CHECK
)
HINT:
This code is output when a problem occurs in a zero point calibration of the steering angle sensor and yaw rate sensor.
Therefore, clear the stored zero point calibration data and correct the zero points.
- Clear the zero point calibration data.
- Perform a zero point calibration of the steering sensor and yaw rate sensor.
- NEXT: Go to next step.
- Is DTC output?
- Clear the DTCs.
- Turn the ignition switch to the ON position.
- Are the same DTCs detected?
- NO: Proceed to next circuit inspection shown in problem symptoms table.
- YES: No problem.
HINT:
When the registered data is not equal to the input data, the DTC will be output.