LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Transfer Case) >> Transfer Oil (4WD) >> Adjustment

Transfer Oil (4WD): Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE EXHAUST PIPE ASSY FRONT (3MZ-FE ENGINE TYPE) (See  REPLACEMENT  ) 
  2. REMOVE EXHAUST PIPE ASSY FRONT (2AZ-FE ENGINE TYPE) (See  REPLACEMENT  ) 
  3. INSPECT TRANSFER OIL 
    1. Remove the No.1 plug and gasket.
    2. Check the oil level is within 0 to 5 mm (0 to 0.1968 in.) down from the lowest end of the hole for No.1 plug.
      NOTE:
      • When changing oil, recheck the oil level after driving.
      • Excessively large or small quantity of oil may cause some trouble.
      Fig 1: Checking Oil Level
      G03033904Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. When the oil level is too low, check for oil leakage.
    4. Tighten the No. 1 plug with a new gasket.

      Torque: 49 N.m (500 kgf.cm, 36 ft.lbf) 

  4. ADD TRANSFER OIL 
    1. Remove the No.1 plug and gasket and supply oil.
      NOTE:
      • When supplying oil, pour it slowly.
      • Repeat supplying oil several times at several minutes interval.

      HINT:

      Within 0 to 5 mm (0 to 0.1968 in.) down from the lowest end of the hole for the No.1 plug.

    2. After leaving it alone for 5 min., check the oil level again.
    3. Tighten the No. 1 plug with a new gasket.
  5. INSTALL EXHAUST PIPE ASSY FRONT (3MZ-FE ENGINE TYPE) (See  REPLACEMENT  ) 
  6. INSTALL EXHAUST PIPE ASSY FRONT (2AZ-FE ENGINE TYPE) (See  REPLACEMENT  ) 
scientia non olet · About LEMON Manuals