Hose Clamping

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

If old rubber hose is re-used, install hose clamp in its original position (at the indentation where the old clamp was). If there is a trace of tube bulging left on the old rubber hose, align rubber hose at that position.
Discard old clamps; replace with new ones.

Fig 1: Identifying Tube Bulge And Hose Trace Clamp
Courtesy of NISSAN NORTH AMERICA, INC.
After installing plate clamps, apply force to them in the direction of the arrow, tightening rubber hose equally all around.

Fig 2: Identifying Force Applying Area On Plate Clamps End
Courtesy of NISSAN NORTH AMERICA, INC.