Component Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SEAT BELT BUCKLE PRE-TENSIONER ASSEMBLY LH (SEAT BELT BUCKLE SWITCH)
1. Turn ignition switch OFF.
2. Disconnect the seat belt buckle pre-tensioner assembly LH (seat belt buckle switch).
3. Check continuity between the seat belt buckle pre-tensioner assembly LH (seat belt buckle switch) terminals 1 and 2.
  1-2
  
  When seat belt is fastened: Continuity should not exist.
  
  When seat belt is unfastened: Continuity should exist.
  
  Fig 1: Checking Continuity Between Seat Belt Buckle Pre-Tensioner Assembly LH Terminals 1 And 2
  Courtesy of NISSAN NORTH AMERICA, INC.
  
  Is the inspection result normal?
  
  YES: Inspection End.
  
  NO: Replace the seat belt buckle pre-tensioner assembly LH (seat belt buckle switch).