COMBINATION METER: Diagnosis Procedure
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".
- CHECK FUSES
Check for blown combination meter fuses.
Unit Power source Fuse No. Combination meter Battery 19 Ignition switch ON or START 14 Ignition switch ACC or ON 4 Is the inspection result normal?
YES: GO TO 2
NO: If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
- POWER SUPPLY CIRCUIT CHECK
- Disconnect combination meter connector M24.
- Check voltage between combination meter harness connector M24 terminals 1, 8, 24 and ground.
Terminals Ignition switch position (+) (-) OFF ACC ON START Connector Terminal M24 1 Ground 0V Battery voltage Battery voltage 0V 8 Battery voltage Battery voltage Battery voltage Battery voltage 24 0V 0V Battery voltage Battery voltage Courtesy of NISSAN NORTH AMERICA, INC.
Is the inspection result normal?
YES: GO TO 3
NO: Check harness for open between combination meter and fuse.
- GROUND CIRCUIT CHECK
- Turn ignition switch OFF.
- Disconnect combination meter connector M23.
- Check continuity between combination meter harness connector M23 terminal 52 and ground, and connector M24 terminal 9 and ground.
Terminals Continuity (+) (-) Connector Terminal A: M23 52 Ground Yes B: M24 9 Courtesy of NISSAN NORTH AMERICA, INC.
Is the inspection result normal?
YES: Inspection End.
NO: Repair or replace harness or connector.