Height Difference Adjustment

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

If an excessive height difference between glass lid assembly and roof panel is found, adjust in the following manner:

Remove headlining. Refer to "REMOVAL AND INSTALLATION ".
Loosen sunroof unit nuts and sunroof bracket bolts.
Add shims until surface height is within specification for "A - A", "B - B" and "C - C".
NOTE: Temporarily snug nuts and bolts to prevent movement between each adjustment.
Tilt glass lid up and down several times to check that it moves and seals properly.
Tighten sunroof unit nuts and sunroof bracket bolts.
NOTE: First tighten left front then right rear sunroof unit to prevent uneven torque while tightening remaining sunroof bracket bolts.
Install headlining. Refer to "REMOVAL AND INSTALLATION ".