Back Door Glass Stay Disposal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Fix back door glass stay (1) using a vise (C).
Using a hacksaw (A), slowly make two holes in the back door glass stay in the numerical order as shown in the figure below.
CAUTION:
- When cutting a hole on back door glass stay, always cover hacksaw using a shop cloth (B) to avoid scattering metal fragments or oil.
- Wear eye protection (safety glasses).
- Wear gloves.
Fig 1: Making Two Holes In Back Door Glass Stay Using Hacksaw
Courtesy of NISSAN NORTH AMERICA, INC.
1. 20 mm (0.8 in)
2. Cut at the groove.
  
  Fig 2: Identifying Cutting Groove Dimension
  Courtesy of NISSAN NORTH AMERICA, INC.