Pedal Adjusting Switch Power Supply and Ground Circuit Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

CHECK PEDAL ADJUSTING SWITCH POWER SUPPLY
1. Turn ignition switch OFF.
2. Disconnect pedal adjusting switch.
3. Check voltage between pedal adjusting switch connector M83 terminal 1 and ground.
  1 - Ground: Battery voltage.
  
  Is inspection result normal?
  
  YES: GO TO 2
  
  NO: Check the following.
  - Repair or replace harness.
  - Circuit breaker-2.
    
    Fig 1: Checking Pedal Adjusting Switch Power Supply Voltage
    Courtesy of NISSAN NORTH AMERICA, INC.
CHECK PEDAL ADJUSTING SWITCH GROUND CIRCUIT
Check continuity between pedal adjusting switch connector M83 terminal 4 and ground.

4 - Ground: Continuity should exist.

Is inspection result normal?

YES: Pedal adjusting switch power supply and ground circuit is OK.

NO: Repair or replace harness.

Fig 2: Checking Pedal Adjusting Switch Ground Circuit Continuity
Courtesy of NISSAN NORTH AMERICA, INC.