LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 925 (Automatic Drive Positioner) >> Ecu Diagnosis Information >> Driver Seat Control Unit >> DTC Index

DTC Index

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT display Timing(1) Item Refer To
Current malfunction Previous malfunction
CAN COMM CIRCUIT
[U1000]
0 1-39 CAN communication U1000 CAN COMM CIRCUIT 
SEAT SLIDE
[B2112]
0 1-39 Seat slide motor output B2112 SLIDING MOTOR 
SEAT RECLINING
[B2113]
0 1-39 Seat reclining motor output B2113 RECLINING MOTOR 
SEAT LIFTER FRONT
[B2114]
0 1-39 Seat lifting motor front output B2114 SEAT LIFTER FR 
SEAT LIFTER REAR
[B2115]
0 1-39 Seat lifting motor rear output B2115 SEAT LIFTER RR 
ADJ PEDAL MOTOR
[B2117]
0 1-39 Pedal adjusting motor output B2117 ADJ PEDAL MOTOR 
ADJ PEDAL SENSOR
[B2120]
0 1-39 Pedal adjusting sensor input B2120 ADJ PEDAL SENSOR 
DETENT SW
[B2126]
0 1-39 Park position switch condition B2126 DETENT SW 
UART COMM
[B2128]
0 1-39 UART communication B2128 UART COMMUNICATION LINE 
  • (1) Current malfunction is present
  • 1-39: Displayed if any previous malfunction is present when current condition is normal. The numeral value increases by one at each IGN ON to OFF cycle from 1 to 39. The counter remains at 39 even if the number of cycles exceeds it. However, the counter is reset to 1 if any malfunction is detected again, the normal operation is resumed and the ignition switch is turned from OFF to ON.