LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 925 (Automatic Drive Positioner) >> Ecu Diagnosis Information >> Automatic Drive Positioner Control Unit >> Reference Value >> Physical Values

Physical Values

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
Terminal No. Wire color Description Condition Voltage (V) (Approx.)
+ - Signal name Input/Output
2 Ground LG Changeover switch RH signal Input Changeover switch position RH 0
Neutral or LH 5
3 Ground Y/B Mirror switch up signal Input Mirror switch Operated (up) 0
Other than above 5
4 Ground V/W Mirror switch left signal Input Mirror switch Operated (left) 0
Other than above 5
5 Ground R/B Door mirror sensor (RH) up/down signal Input Door mirror RH position Peak 3.4
Valley 0.6
6 Ground L/Y Door mirror sensor (LH) up/down signal Input Door mirror LH position Peak 3.4
Valley 0.6
8 Ground BR/Y Pedal sensor input signal Input Pedal sensor Forward 0.5
Backward 4.5
9 Ground LG/B Memory switch 1 signal Input Memory switch 1 Push 0
Other than above 5
10 Ground L UART LINE (TX) Output Ignition switch ON
G04902962
12 Ground P Memory indicator 1 signal Output Memory indictor 1 Illuminate 0
Other than above Battery voltage
13 Ground Y/G Memory indicator 2 signal Output Memory indictor 2 Illuminate 0
Other than above Battery voltage
14 Ground GR/R Door mirror motor (RH) up output signal Output Door mirror RH Operate (up) 1.5 - Battery voltage
Other than above 0
15 Ground V/R Door mirror motor (RH) left output signal Output Door mirror RH Operate (left) 1.5 - Battery voltage
Other than above 0
16 Ground O Door mirror motor (LH) down output signal Output Door mirror (LH) Operate (down) 1.5 - Battery voltage
Other than above 0
Door mirror motor (LH) right output signal Operate (right) 1.5 - Battery voltage
Other than above 0
18 Ground BR/W Changeover switch LH signal Input Changeover switch position LH 0
Neutral or RH 5
19 Ground SB Mirror switch down signal Input Mirror switch Operate (down) 0
Other than above 5
20 Ground GR Mirror switch right signal Input Mirror switch Operate (right) 0
Other than above 5
21 Ground L/W Door mirror sensor (RH) left/right signal Input Door mirror RH position Left edge 3.4
Right edge 0.6
22 Ground G Door mirror sensor (LH) left/right signal Input Door mirror LH position Left edge 0.6
Right edge 3.4
24 Ground G/O Set switch signal Input Set switch Push 0
Other than above 5
25 Ground P/L Memory switch 2 signal Input Memory switch 2 Push 0
Other than above 5
26 Ground W UART LINE (RX) Input Ignition switch ON
G04902965
30 Ground Y Door mirror motor (RH) down output signal Output Door mirror (RH) Operate (down) 1.5 - Battery voltage
Other than above 0
Door mirror motor (RH) right output signal Operate (right) 1.5 - Battery voltage
Other than above 0
31 Ground R Door mirror motor (LH) up output signal Output Door mirror (LH) Operate (up) 1.5 - Battery voltage
Other than above 0
32 Ground BR Door mirror motor (LH) left output signal Output Door mirror (LH) Operate (left) 1.5 - Battery voltage
Other than above 0
33 Ground W/L Sensor power supply Input - 5
34 Ground Y/R Battery power source Input - Battery voltage
37 Ground G Pedal adjusting motor forward output signal Output Pedal adjusting motor Operate (forward) Battery voltage
Other than above 0
39 Ground L/B Battery power source   - Battery voltage
40 Ground B/W Ground - - 0
41 Ground W/G Sensor ground - - 0
45 Ground R Pedal adjusting motor backward output signal Output Pedal adjusting motor Operate (backward) Battery voltage
Other than above 0
48 Ground B Ground - - 0