Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK SEAT MEMORY INDICATOR CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect automatic drive positioner control unit and seat memory switch.
   3. Check continuity between automatic drive positioner control unit harness connector and seat memory switch harness connector.

      Automatic drive positioner control unit connector	Terminal	Seat memory switch connector	Terminal	Continuity
      M33	12	D5	6	Yes
      	13		7

      Fig 1: Checking Seat Memory Indicator Circuit Continuity

      Courtesy of NISSAN NORTH AMERICA, INC.
   4. Check continuity between automatic drive positioner control unit harness connector and ground.

      Automatic drive positioner connector	Terminal	Ground	Continuity
      M33	12		No
      	13

      Is the inspection result normal? 

      YES: GO TO 2

      NO: Repair or replace harness.

2. CHECK MEMORY INDICATOR POWER SUPPLY 

   Check voltage between seat memory switch harness connector and ground.

   Seat memory switch connector	Terminals		Voltage (V) (Approx.)
   	(+)	(-)
   D5	5	Ground	Battery voltage

   Is the inspection result normal? 

   YES: GO TO 3

   NO: Check the following.

   • 15A fuse no. 22
   • Harness for open or short between memory indicator and fuse.
     Fig 2: Checking Memory Indicator Power Supply Voltage

     Courtesy of NISSAN NORTH AMERICA, INC.
3. CHECK MEMORY INDICATOR 

   Refer to "COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 4

   NO: Replace seat memory switch. Refer to "REMOVAL AND INSTALLATION ".

4. CHECK INTERMITTENT INCIDENT 

   Refer to "INTERMITTENT INCIDENT ".

   Is the inspection result normal? 

   YES: Replace automatic drive positioner control unit. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace the malfunctioning part.