LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 925 (Automatic Drive Positioner) >> DTC/Circuit Diagnosis >> Front Door Switch (Driver Side) >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

  1. CHECK FRONT DOOR SWITCH LH CIRCUIT 
    1. Disconnect BCM and front door switch LH.
    2. Check continuity between BCM connector and front door switch LH connector.
      BCM connector Terminal Front door switch LH connector Terminal Continuity
      M19 47 B8 2 Yes
    3. Check continuity between BCM connector and ground.
      BCM connector Terminal Ground Continuity
      M19 47 No
      Fig 1: Checking Front Door Switch LH Circuit Continuity
      G04903071Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: GO TO 2

      NO: Repair or replace harness.

  2. CHECK FRONT DOOR SWITCH LH 

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 3

    NO: Replace front door switch LH.

  3. CHECK INTERMITTENT INCIDENT 

    Refer to "INTERMITTENT INCIDENT ".

    Is the inspection result normal? 

    YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

    NO: Repair or replace the malfunctioning part.