CHANGEOVER SWITCH: Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK CHANGEOVER SWITCH SIGNAL 
   1. Turn ignition switch to ACC.
   2. Check voltage between automatic drive positioner control unit connector and ground.

      Terminals			Change over switch condition	Voltage (V) (Approx.)
      (+)		(-)
      Automatic drive positioner control unit connector	Terminal
      M33	2	Ground	RIGHT	0
      			Other than above	5
      	18		LEFT	0
      			Other than above	5

      Fig 1: Checking Changeover Switch Signal Voltage

      Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: GO TO  6

      NO: GO TO 2

2. CHECK HARNESS CONTINUITY 
   1. Turn ignition switch OFF.
   2. Disconnect automatic drive positioner control unit and door mirror remote control switch.
   3. Check continuity between automatic drive positioner control unit connector and door mirror remote control switch connector.

      Automatic drive positioner control unit connector	Terminal	Door mirror remote control switch connector	Terminal	Continuity
      M33 (A)	2	D10 (B)	11	Yes
      	18		10

      Fig 2: Checking Continuity Between Automatic Drive Positioner Control Unit & Door Mirror Remote Control Switch

      Courtesy of NISSAN NORTH AMERICA, INC.
   4. Check continuity between automatic drive positioner control unit connector and ground.

      Automatic drive positioner control unit connector	Terminal	Ground	Continuity
      M33 (A)	2		No
      	18

      Is the inspection result normal? 

      YES: GO TO 3

      NO: Repair or replace harness.

3. CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT 

   Check continuity between door mirror remote control switch connector and ground.

   Door mirror remote control switch connector	Terminal	Ground	Continuity
   D10	7		Yes

   Is the inspection result normal? 

   YES: GO TO 4

   NO: Repair or replace harness.

   Fig 3: Checking Door Mirror Remote Control Switch Ground Circuit Continuity

   Courtesy of NISSAN NORTH AMERICA, INC.
4. CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL 
   1. Connect automatic drive positioner control unit.
   2. Turn ignition switch to ACC.
   3. Check voltage between automatic drive positioner control unit connector and ground.

      Terminals			Voltage (V) (Approx.)
      (+)		(-)
      Automatic drive positioner control unit connector	Terminal
      M33	2	Ground	5
      	18

      Fig 4: Checking Automatic Drive Positioner Control Unit Output Signal Voltage

      Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: GO TO 5.

      NO: Replace automatic drive positioner control unit. Refer to "REMOVAL AND INSTALLATION ".

5. CHECK CHANGEOVER SWITCH 

   Check changeover switch.

   Refer to "CHANGEOVER SWITCH: COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: Refer to "INTERMITTENT INCIDENT ".

   NO: Replace door mirror remote control switch. Refer to "REMOVAL AND INSTALLATION ".

6. CHECK INTERMITTENT INCIDENT 

   Check intermittent incident.

   Refer to "INTERMITTENT INCIDENT ".

   Is the inspection result normal? 

   YES: Replace automatic drive positioner control unit. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace the malfunctioning parts.