LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 923 (Power Window Control System) >> DTC/Circuit Diagnosis >> Rear Power Vent Window Relay (Close) Check >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

  1. CHECK REAR POWER VENT WINDOW RELAY (CLOSE) POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect rear power vent window relay (CLOSE).
    3. Turn ignition switch ON.
    4. Check voltage between rear power vent window relay (CLOSE) connector and ground.
      Connector Terminals Voltage (V) (Approx.)
      (+) (-)
      M89 1 Ground Battery voltage
      5
      Fig 1: Checking Voltage Between Rear Power Vent Window Relay Connector And Ground
      G04902803Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: GO TO 2

      NO: Repair or replace harness.

  2. CHECK REAR POWER VENT WINDOW RELAY (CLOSE) 

    Check continuity between rear power vent window relay (CLOSE) terminals 3 and 4, 3 and 5.

    Terminals Condition Continuity
    3 4 12V direct current supply between terminals 1 and 2 No
    No current supply Yes
    3 5 12V direct current supply between terminals 1 and 2 Yes
    No current supply No
    Fig 2: Checking Continuity Between Rear Power Vent Window Relay Terminals 3 And 4, 3 And 5
    G04901494Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal? 

    YES: GO TO 3

    NO: Replace rear power vent window relay (CLOSE).

  3. CHECK REAR POWER VENT WINDOW RELAY (CLOSE) GROUND CIRCUIT 
    1. Turn ignition switch OFF.
    2. Check continuity between rear power vent window relay (CLOSE) connector M89 terminal 4 and ground.

      4 - Ground: Continuity should exist. 

      Fig 3: Checking Continuity Between Rear Power Vent Window Relay Connector M89 Terminal 4 And Ground
      G04902805Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: GO TO 4

      NO: Repair or replace harness.

  4. CHECK REAR POWER VENT WINDOW RELAY (CLOSE) CIRCUIT 
    1. Disconnect rear power vent window switch.
    2. Check continuity between rear power vent window relay (CLOSE) connector M89 terminal 2 and rear power vent window switch M95 terminal 4.

      2 - 4: Continuity should exist. 

      Fig 4: Checking Continuity Between Rear Power Vent Window Relay Connector M89 Terminal 2 And Rear Power Vent Window Switch M95 Terminal 4
      G04902810Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: Replace rear power vent window switch. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.