LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 923 (Power Window Control System) >> DTC/Circuit Diagnosis >> Power Supply And Ground Circuit >> Power Window Main Switch >> POWER WINDOW MAIN SWITCH: Component Inspection

POWER WINDOW MAIN SWITCH: Component Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH 
    1. Check main power window and door lock/unlock switch.
      Terminal Main power window and door lock/unlock switch condition Continuity
      10 1 Rear LH UP Yes
      10 7 Rear RH
      1 3 Rear LH NEUTRAL
      5 7 Rear RH
      10 3 Rear LH DOWN
      10 5 Rear RH
      Fig 1: Checking Main Power Window And Door Lock/Unlock Switch
      G05046736Courtesy of NISSAN NORTH AMERICA, INC.
    2. Check continuity between main power window and door lock/unlock switch (power window lock switch). (Lock operation).
      Terminal Main power window and door lock/unlock switch condition Continuity
      3 17 Rear LH UP No
      5 Rear RH
      1 Rear LH NEUTRAL
      3
      5 Rear RH
      7
      1 Rear LH DOWN
      7 Rear RH
      Fig 2: Checking Continuity Between Main Power Window And Door Lock/Unlock Switch (Lock Operation)
      G05046737Courtesy of NISSAN NORTH AMERICA, INC.
    3. Check continuity between main power window and door lock/unlock switch (power window lock switch). (Unlock operation).
      Terminal Main power window and door lock/unlock switch condition Continuity
      3 17 Rear LH UP Yes
      5 Rear RH
      1 Rear LH NEUTRAL
      3
      5 Rear RH
      7
      1 Rear LH DOWN
      7 Rear RH
      Fig 3: Checking Continuity Between Main Power Window And Door Lock/Unlock Switch (Unlock Operation)
      G05046737Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: Main power window and door lock/unlock switch is OK.

      NO: Replace main power window and door lock/unlock switch. Refer to "REMOVAL AND INSTALLATION ".