Element Check

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Attach probe circuit tester (ohm setting) to antenna terminal on each side.

Fig 1: Attaching Probe Circuit Tester To Antenna Terminal
Courtesy of NISSAN NORTH AMERICA, INC.
- When measuring continuity, wrap tin foil around the top of probe. Then, press the foil against the wire with your finger.
  
  Fig 2: Pressing Tin Foil Against Wire
  Courtesy of NISSAN NORTH AMERICA, INC.
If an element is broken, no continuity will exist.

Fig 3: Checking Element Continuity (For Breakpoint)
Courtesy of NISSAN NORTH AMERICA, INC.
To locate a break, move probe along element. Tester indication will change abruptly when probe passes the broken point.

Fig 4: Moving Probe Along Element
Courtesy of NISSAN NORTH AMERICA, INC.