Diagnosis Procedure
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".
- CHECK CONTINUITY RGB (R: RED) SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect display unit connector M93 and AV control unit connector M44.
- Check continuity between display unit harness connector M93 (A) terminal 17 and AV control unit harness connector M44 (B) terminal 40.
A B Continuity Connector Terminal Connector Terminal M93 17 M44 40 Yes - Check continuity between display unit harness connector M93 (A) terminal 17 and ground.
Courtesy of NISSAN NORTH AMERICA, INC.
A - Continuity Connector Terminal M93 17 Ground No Are the continuity results as specified?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK RGB (R: RED) SIGNAL
- Connect display unit connector M93 and AV control unit connector M44.
- Turn ignition switch ON.
- Check signal between display unit harness connector M93 terminal 17 and ground.
(+) (-) Condition Reference signal Connector Terminal M93 17 Ground Receive audio signal Courtesy of NISSAN NORTH AMERICA, INC.
Are the voltage readings as specified?
YES: Replace display unit. Refer to "REMOVAL AND INSTALLATION ".
NO: Replace AV control unit. Refer to "REMOVAL AND INSTALLATION ".