Rear Heater And Cooling Unit Assembly: Installation
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse O-rings.
- Apply A/C oil to the O-ring of the low-pressure pipe and high-pressure pipe for installation
- After charging the refrigerant, check for leaks.
NOTE:
- Fill the engine cooling system with the specified coolant mixture. Refer to "CHANGING ENGINE COOLANT ".
- Recharge the A/C system. Refer to "HFC-134A (R-134A) SERVICE PROCEDURE ".