LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (SRS Airbag Control System) >> System Description >> On Board Diagnostic (OBD) System >> Self-Diagnosis Function (Without CONSULT) >> Diagnostic Procedure 3 >> Final Check of SRS Using CONSULT-Diagnosis Mode

Final Check of SRS Using CONSULT-Diagnosis Mode

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect CONSULT.
  2. If no DTC is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 3.

    If any DTC is detected on "SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Perform DIAGNOSTIC PROCEDURE 2. Refer to "SRS OPERATION CHECK ".

  3. Touch "ERASE".
    NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST] ").

    If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.

  4. Touch "BACK" key of CONSULT. Touch "SELF-DIAG [PAST]".
  5. Check that no malfunction is detected on "SELF-DIAG [PAST]".
  6. Touch "BACK" key of CONSULT to return to User mode from Diagnosis mode.
  7. Turn ignition switch OFF and then turn off and disconnect CONSULT.
  8. Go to "SRS OPERATION CHECK ".
scientia non olet · About LEMON Manuals