Diagnostic Procedure
- CHECK CONDITION OF AIR BAG MODULE
Inspect for any deployed air bag modules or seat belt pre-tensioners.
Are any air bag modules or seat belt pre-tensioners deployed?
YES: Refer to "FOR FRONTAL COLLISION " or "FOR SIDE AND ROLLOVER COLLISION ".
NO: GO TO 2
- CHECK THE AIR BAG FUSE
Check 10A fuse [No. 13, located in the fuse block (J/B)].
Is the fuse blown?
Yes: GO TO 3
No: GO TO 4
- CHECK AIR BAG FUSE AGAIN
Replace 10A fuse [No. 13, located in the fuse block (J/B)] and turn ignition switch ON.
Does the fuse blow again?
YES: Replace harness.
NO: Inspection End.
- CHECK AIR BAG DIAGNOSIS SENSOR UNIT
Connect CONSULT.
Is "AIR BAG" displayed on CONSULT?
YES: GO TO 5
NO: Visually inspect the air bag diagnosis sensor unit harness connections. If the connections are OK, replace the air bag diagnosis sensor unit. Refer to "REMOVAL AND INSTALLATION ".
- CHECK HARNESS CONNECTION
Check for loose connections between the combination meter and the air bag diagnosis sensor unit.
Are there any loose connections?
Yes: Properly connect the combination meter and air bag diagnosis sensor unit harness connectors. If "AIR BAG" warning lamp still does not turn off, replace the wiring harness.
No: Replace air bag diagnosis sensor unit. Refer to "REMOVAL AND INSTALLATION ".