Physical Values
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
| Terminal (Wire color) | Description | Condition | Reference value (Approx.) | |||
|---|---|---|---|---|---|---|
| + | - | Signal name | Input/Output | |||
| 1 (GR/L) | Ground | Amp. ON signal | Output | Ignition switch ON | - | 12V |
| 2 (LG) | 3 (V) | Pre-amp. audio signal front LH | Output | Ignition switch ON | Audio output | |
| 4 (L) | 5 (B/W) | Pre-amp. audio signal rear LH | Output | Ignition switch ON | Audio output | |
| 6 (Y) | Ground | Steering switch signal A | Input | Ignition switch ON | Press and hold SOURCE switch. | 0V |
| Press and hold Δ switch. | 1.0V | |||||
| Press and hold DOWN TRIANGLE switch. | 2.0V | |||||
| Press and hold |
3.0V | |||||
| Press and hold ENTER switch. | 4.0V | |||||
| Except for above. | 5.0V | |||||
| 7 (V) | Ground | ACC power supply | Input | Ignition switch ACC | - | Battery voltage |
| 10 | - | Shield | - | - | - | - |
| 11 (BR) | 12 (B/R) | Pre-amp. audio signal front RH | Output | Ignition switch ON | Audio output | |
| 13 (W) | 14 (B) | Audio signal rear RH | Output | Ignition switch ON | Audio output | |
| 15 | Ground | Steering switch signal ground | - | Ignition switch ON | - | 0V |
| 16 (BR) | Ground | Steering switch signal B | Input | Ignition switch ON | Press and hold |
0V |
| Press and hold |
1.0V | |||||
| Press and hold |
2.0V | |||||
| Press and hold |
3.0V | |||||
| Except for above | 5.0V | |||||
| 19 (Y) | Ground | Battery power supply | Input | Ignition switch OFF | - | Battery voltage |
| 20 (B) | Ground | Ground | - | Ignition switch ON | - | 0V |
| 24 (W) | 39 (B) | AUX sound signal LH | Input | Ignition switch ON | When front AUX mode is selected. | |
| 37 | - | Shield | - | - | - | - |
| 38 (R) | 39 (B) | AUX sound signal RH | Input | Ignition switch ON | When front AUX mode is selected. | |
| 53 (G) | Ground | Parking brake signal | Input | Ignition switch ON | Parking brake is applied. | 0 V |
| Parking brake is released. | 4.5 V | |||||
| 54 (B) | Ground | Ground | - | Ignition switch ON | - | 0V |
| 55 (R) | Ground | Composite image signal ground | - | Ignition switch ON | - | 0 V |
| 56 (W) | Ground | Composite image signal | Output | Ignition switch ON | At DVD image is displayed. | |
| 59 | - | Shield | - | - | - | - |
| 60 (W) | Ground | Microphone VCC | Output | Ignition switch ON | - | 5.0 V |
| 61 (V) | Ground | Communication signal (CONT→DISP) | Output | Ignition switch ON | When adjusting display brightness. | |
| 62 (P) | - | CAN-L | Input/Output | - | - | - |
| 63 (P/B) | - | AV communication signal (L) | Input/Output | - | - | - |
| 64 (B/P) | - | AV communication signal (L) | Input/Output | - | - | - |
| 67 (R/L) | - | MR output | - | - | - | - |
| 68 (G/R) | Ground | Ignition signal | Input | Ignition switch ON | - | Battery voltage |
| 69 (G/W) | Ground | Reverse signal | Input | Ignition switch ON | Selector lever is in R position. | Battery voltage |
| Selector lever is in other than R position. | 0 V | |||||
| 70 (W/R) | Ground | Vehicle speed signal (8-pulse) | Input | Ignition switch ON | When vehicle speed is approx. 40 km/h (25 MPH) |
NOTE:
The maximum voltage varies depending on the specification (destination unit).
|
| 71 | - | Shield | - | - | - | - |
| 72 (B) | Ground | Ground | Input | Ignition switch ON | - | 0V |
| 75 (B) | 59 | Microphone signal | Input | Ignition switch ON | Give a voice. | |
| 76 | - | Shield | - | - | - | - |
| 77 (LG) | Ground | Communication signal (DISP→CONT) | Input | Ignition switch ON | When adjusting display brightness. | |
| 78 (L) | - | CAN-H | Input/Output | - | - | - |
| 79 (W/L) | - | AV communication signal (H) | Input/Output | - | - | - |
| 80 (L/W) | - | AV communication signal (H) | Input/Output | - | - | - |
| 91 (W) | Ground | AUX image signal | Input | Ignition switch ON | At front AUX image is displayed. | |
| 92 (B) | Ground | AUX image signal ground | - | Ignition switch ON | - | 0 V |
| 93 (B) | Ground | Ground | Input | Ignition switch ON | - | 0V |
| 94 | - | Shield | - | - | - | - |
| 95 (B) | Ground | Camera image signal | Input | Ignition switch ON | Camera image displayed | |
| 97 (SB) | Ground | Disk eject signal | Input | Ignition switch ON | Pressing the eject switch. | 0 V |
| Except for above. | 5.0 V | |||||
| 98 (B) | Ground | Switch ground | - | Ignition switch ON | - | 0 V |
| 99 (B) | Ground | EQ mode ground | Input | Ignition switch ON | - | 0V |
| 100 (B) | Ground | Ground | Input | Ignition switch ON | - | 0V |
| 102 (B) | Ground | Ground | Input | Ignition switch ON | - | 0V |
| 121 | Ground | Antenna amp. ON signal | Output | Ignition switch ACC | - | 12V |
| 122 | - | Amplified window antenna signal | Input | - | - | - |
| 123 | - | GPS antenna signal | - | - | - | - |
| 124 | - | Shield | - | - | - | - |
| 125 | - | Satellite antenna signal | Input | Ignition switch ACC | - | - |
| 126 | - | Shield | - | - | - | - |
| 127 (W) | - | V BUS signal | - | - | - | - |
| 128 (G) | - | USB ground | - | - | - | - |
| 129 (L) | - | USB D+ signal | - | - | - | - |
| 130 (R) | - | USB D- signal | - | - | - | - |
| 131 | - | Shield | - | - | - | - |
| 132 | - | Shield | - | - | - | - |
| 133 | - | Shield | - | - | - | - |
| 134 (B) | Ground | RGB digital image signal (-) | Output | Ignition switch ON | Connector not connected. | 1.3 V |
| 135 (B) | Ground | RGB digital image signal (+) | Output | Ignition switch ON | Connector not connected. | 1.3 V |