Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

CHECK STEERING WHEEL AUDIO CONTROL SWITCH RESISTANCE

Disconnect combination switch connector M102.

Check resistance between combination switch connector terminals.

Terminal		Signal name	Condition	Resistance (Ω) (Approx.)
16	17	Volume (down)	Depress switch.	1
		Volume (up)	Depress switch.	121
		Phone	Depress switch.	321
		Back	Depress switch.	723
20	17	Source	Depress SOURCE switch.	1
		Seek (up)	Depress Δ switch.	121
		Seek (down)	Depress DOWN TRIANGLE switch.	321
		Phone/Send	Depress switch.	723
		Enter	Depress ENTER switch.	2023

Fig 1: Checking Resistance Between Steering Switch Terminals

Courtesy of NISSAN NORTH AMERICA, INC.

Do the steering wheel audio control switches check OK?

YES: GO TO 2.

NO: Replace steering wheel audio control switch. Refer to "REMOVAL AND INSTALLATION ".

CHECK HARNESS

Turn ignition switch OFF.
Disconnect AV control unit connector M161 and combination switch connector M30.

Check continuity between AV control unit harness connector M161 and combination switch harness connector M30.

AV control unit		Combination switch		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M161	6	M30	24	Yes
	15		31
	16		25

Check continuity between AV control unit connector M161 and ground.

AV control unit		-	Continuity
Connector	Terminal	-	Continuity
M161	6	Ground	No
	15
	16

Are the continuity results as specified?

YES: GO TO 3.

NO: Repair harness.

SPIRAL CABLE CHECK

Check continuity between combination switch harness connectors M30 and M102.

Combination switch				Continuity
Connector	Terminal	Connector	Terminal	Continuity
M30	24	M102	20	Yes
	31		17
	25		16

Does the spiral cable check OK?

YES: Inspection End.

NO: Replace spiral cable. Refer to "REMOVAL AND INSTALLATION ".