Passenger Seat
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUSE
Check that the fuse is not blown.
Terminal Signal name Fuse No. 2 Ignition switch ACC or ON 4 Is the fuse OK?
YES: GO TO 2.
NO: If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between headrest display unit (passenger seat) connector B306 and ground.
(+) (-) Value (Approx.) Connector Terminal B306 12 Ground Battery voltage Does specified voltage exist?
YES: GO TO 3.
NO: Repair harness or connector.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect headrest display unit (passenger seat) connector.
- Check continuity between headrest display unit (passenger seat) connector B306 and ground.
Connector Terminal - Continuity B306 18 Ground Yes Does continuity exist?
YES: Inspection End.
NO: Repair harness or connector.