Removal and Installation: Removal
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Clean the brakes with a vacuum dust collector to minimize the hazard of airborne particles or other materials.
NOTE:
Remove the disc rotor only with the parking brake pedal completely in the released position.
- Remove the rear hub assembly. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
- Remove the return springs.
- Remove the adjuster.
- Disconnect the rear cable from the toggle lever, if necessary.
- Remove pin retainer and withdraw cable end from toggle lever.
- Remove the retainers, anti-rattle pins and shoes.