LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 916 (Parking Brake System) >> Removal And Installation >> Parking Brake Control >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove instrument lower panel LH. Refer to "EXPLODED VIEW ".
  2. Remove center console. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove floor trim. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove adjusting nut and discard.
    CAUTION: Do not reuse adjusting nut after removing it.
  5. Remove the lock plate from the front cable.
  6. Remove front cable retaining bolts and nut.
  7. Disconnect return spring from equalizer.
  8. Disconnect right and left rear cables from equalizer.
  9. Remove rear hub assemblies. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
    Fig 1: Identifying Parking Brake Pedal Adjusting Nut
    G04902235Courtesy of NISSAN NORTH AMERICA, INC.
  10. Remove parking brake shoes, and remove rear cables from toggle levers. Refer to "COMPONENT ".
  11. Remove right and left rear cable retaining bolts and nuts, then remove right and left rear cables.
scientia non olet · About LEMON Manuals