Initialization Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If control unit has been replaced, proceed to step 3.

CLEAR INITIALIZATION FLAG AND VALUE
1. Using CONSULT select "CLEAR HEIGHT INI" in "WORK SUPPORT".
2. Select "Start" to clear initialization flag and value.
3. CK SUSP. warning lamp in combination meter should illuminate.
  : GO TO 2
RELEASE AIR PRESSURE FROM REAR LOAD LEVELING SUSPENSION
1. Select "EXHAUST SOLENOID" in "ACTIVE TEST".
2. Select "On" to release the air pressure from the rear load leveling air suspension system.
  : GO TO 3
MOVE VEHICLE
Roll vehicle forward and backward.

: GO TO 4
SET INITIALIZATION CONDITION
1. Select "ADJUST HEIGHT INI" in "WORK SUPPORT".
2. Select "Start" to set initialization condition.
3. Confirm that CK SUSP. warning lamp in combination meter is OFF.
  :Initialization complete.