Removal and Installation: Installation
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse the lower link ball joint nut.
- Do not reuse the upper link ball joint cotter pin.
- Tighten all nuts and bolts to specification. Refer to "EXPLODED VIEW ".
- When installing disc rotor on wheel hub and bearing assembly, align the marks.
- Check the wheel alignment. Refer to "FRONT WHEEL ALIGNMENT ".
- Adjust the neutral position of the steering angle sensor. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION: SPECIAL REPAIR REQUIREMENT ".