LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 914 (Front Suspension) >> Periodic Maintenance >> On-Vehicle Service >> Front Wheel Alignment >> Preliminary Inspection

Preliminary Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Always adjust the alignment with the vehicle on a flat surface.
NOTE: If alignment is out of specification, inspect and replace any damaged or worn suspension parts before making any adjustments.
  1. Check and adjust the wheel alignment with the vehicle under unladen conditions. "Unladen conditions" means that the fuel, coolant, and lubricant are full; and that the spare tire, jack, hand tools and mats are in their designated positions.
  2. Check the tires for incorrect air pressure and excessive wear.
  3. Check the wheels for run out and damage. Refer to "INSPECTION ".
  4. Check the wheel bearing axial end play. Refer to "ON-VEHICLE INSPECTION AND SERVICE ".
  5. Check the shock absorbers for leaks or damage.
  6. Check each mounting point of the suspension components for any excessive looseness or damage.
  7. Check each link, arm, and the rear suspension member for any damage.
  8. Check the vehicle height. Refer to "WHEELARCH HEIGHT (UNLADEN*1) ".
scientia non olet · About LEMON Manuals