LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 913 (Rear Suspension) >> Removal And Installation >> Suspension Arm >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear suspension member using power tool. Refer to "REMOVAL AND INSTALLATION ".
    NOTE: It is necessary to remove the rear suspension member to remove the front upper bolt from the suspension arm.
  2. Remove the shock absorber upper end bolt.
  3. Remove the suspension arm upper nuts and bolts on the suspension member side using power tool.
    Fig 1: Identifying Shock Absorber Upper And Lower End Bolts
    G04902126Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the suspension arm pinch bolt and nut on the knuckle side using power tool.
  5. Disconnect the suspension arm from the knuckle using a soft hammer.
    CAUTION: Do not damage the ball joint with the soft hammer.
    Fig 2: Identifying Suspension Arm Pinch Bolt And Nut
    G04902128Courtesy of NISSAN NORTH AMERICA, INC.
  6. Remove the suspension arm.
scientia non olet · About LEMON Manuals