Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Tighten the nuts and bolts to specification. Refer to "EXPLODED VIEW ".
Install the stabilizer bar with the ball joint sockets properly aligned.

Fig 1: Identifying Stabilizer Bar And Ball Joint Sockets (OK And NG)
Courtesy of NISSAN NORTH AMERICA, INC.
Install the stabilizer bar bushing and clamp so they are positioned inside of the sideslip prevention clamp on the stabilizer bar.