Removal and Installation: Installation
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
CAUTION:
Do not reuse the rear lower link nuts.
- Tighten the nuts and bolts to specification. Refer to "EXPLODED VIEW ".
- When installing the upper and lower rubber seats for the rear coil springs, the arrow embossed on the rubber seats must point out toward the wheel and tire assembly.
- Check the wheel alignment. Refer to "WHEEL ALIGNMENT INSPECTION ".
- Adjust the neutral position of the steering angle sensor. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION: SPECIAL REPAIR REQUIREMENT ".