Removal and Installation: Installation
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
- Start the engine.
- Use CONSULT to perform "STANDARD HEIGHT LEVEL" work support function.
- Using data monitor of CONSULT, verify "HEIGT CALC" is at 0 mm.
- Check the vehicle height. Refer to "WHEELARCH HEIGHT (UNLADEN*1) ". If vehicle height is not within ± 10 mm (0.39 in) of the specification, perform the initialization procedure. Refer to "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: SPECIAL REPAIR REQUIREMENT ".