LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 913 (Rear Suspension) >> Removal And Installation >> Control Unit >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the luggage side finisher lower and upper (LH). Refer to "REMOVAL AND INSTALLATION ".
  2. Disconnect the battery negative terminal. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect the suspension control unit harness connector.
  4. Remove the two bolts and remove the suspension control unit.
    Fig 1: Identifying Suspension Control Unit
    G04902148Courtesy of NISSAN NORTH AMERICA, INC.