Wheel Alignment Inspection: Toe-In

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Measure the toe-in of the rear wheels. If out of specification, inspect and replace any damaged or worn rear suspension parts before adjusting.
Total toe-in: Refer to "WHEEL ALIGNMENT (UNLADEN*1) ".
Adjust toe-in by turning adjusting bolt on rear lower link.
CAUTION: Be sure to adjust equally on RH and LH sides using the adjusting bolt.

NOTE: Toe changes about 1.5 mm (0.059 in) [one side] with each graduation of the adjusting bolt.
After adjusting, tighten the adjusting bolt nut to the specified torque.
Adjusting bolt nut: Refer to "EXPLODED VIEW ".

Fig 1: Identifying Adjusting Bolt And Rear Lower Link
Courtesy of NISSAN NORTH AMERICA, INC.