Wheel Alignment Inspection: Camber

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Measure camber of both the right and left wheels and adjust as necessary to specification.
Camber: Refer to "WHEEL ALIGNMENT (UNLADEN*1) ".

Fig 1: Identifying Adjusting Bolt And Front Lower Link
Courtesy of NISSAN NORTH AMERICA, INC.
If outside of the specified value, adjust the camber using the adjusting bolt in the front lower link.
CAUTION: After adjusting the camber then check the toe-in.

NOTE: Camber changes about 0° 5' with each graduation of the adjusting bolt.
Tighten the adjusting bolt nuts to specification.