LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 912 (Rear Axle) >> Unit Removal And Installation >> Wheel Hub >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire using power tool. Refer to "ROTATION ".
  2. Remove the rear brake caliper, without disconnecting the hydraulic hose, using power tool. Reposition the rear brake caliper aside using suitable wire. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
    NOTE:
    • Do not depress the brake pedal while the brake caliper is removed.
  3. Remove the rear disc rotor.
  4. Remove the cotter pin and adjusting cap, then remove the nut from the rear drive shaft using power tool.
    • Discard the cotter pin, use a new one for installation.
  5. Remove the rear drive shaft. Refer to REAR DRIVE SHAFT .
    Fig 1: Identifying Driving Shaft Nut
    G04902021Courtesy of NISSAN NORTH AMERICA, INC.
  6. Remove the wheel hub and bearing assembly bolts using power tool.
    • Discard the wheel hub and bearing assembly bolts, use new ones for installation.
  7. Pull out the wheel hub and bearing assembly for access to remove the rear ABS sensor from the wheel hub and bearing assembly as shown below.
    CAUTION: Do not pull on the rear ABS sensor harness.
  8. Remove the wheel hub and bearing assembly.
    Fig 2: Removing Rear ABS Sensor From Wheel Hub And Bearing Assembly Using Tool
    G04902022Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals