Removal and Installation: Installation
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
- Apply grease 44003 7S000 to contact surface between wheel hub and rear drive shaft. Use sufficient grease to completely coat contact area.
- Inspect the rear ABS sensor O-ring, replace the rear ABS sensor assembly if damaged.
- Clean the rear ABS sensor hole and mounting surface with a suitable brake cleaner and a clean lint-free shop rag. Be careful that dirt and debris do not enter the axle bearing area.
- Apply a coat of suitable grease to the rear ABS sensor O-ring and mounting hole.
- Use a new cotter pin for installation.
- Use new wheel hub and bearing assembly bolts for installation.