Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Do not reuse the rear drive shaft inside flange bolts and washers, discard after removal and use new bolts and washers for installation.
Do not reuse the cotter pin, discard after removal and use a new cotter pin for installation.
Rear drive shaft lock nut: Refer to REAR DRIVE SHAFT .

Rear drive shaft inside flange bolts: Refer to REAR DRIVE SHAFT .