LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 911 (Rear Final Drive (R230)) >> Unit Removal And Installation >> Rear Final Drive >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the spare tire.
  2. Remove the rear stabilizer bar. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove the rear propeller shaft. Refer to "UNIT REMOVAL AND INSTALLATION ".
  4. Remove the rear drive shafts from the rear final drive assembly and support them using suitable wire. Refer to "REMOVAL AND INSTALLATION ".
    Fig 1: Supporting Rear Drive Shaft Using Suitable Wire
    G04901933Courtesy of NISSAN NORTH AMERICA, INC.
  5. Disconnect the breather hose from the rear final drive assembly.
  6. Place a suitable jack under the rear final drive assembly.
    CAUTION: Do not place the jack on the carrier cover.
  7. Remove the nuts and bolts (<==) and remove the rear final drive assembly.
    CAUTION: Secure rear final drive assembly to the jack while removing it.
    Fig 2: Supporting Rear Final Drive Assembly Using Suitable Jack
    G04901934Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals