LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 911 (Rear Final Drive (R230)) >> Unit Disassembly And Assembly >> Rear Final Drive >> Disassembly and Assembly >> Assembly Inspection And Adjustment >> Drive Gear Runout

Drive Gear Runout

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit a dial indicator to the drive gear back face.
  2. Rotate the drive gear to measure runout.

    Runout limit: 0.05 mm (0.0020 in) or less 

    Fig 1: Measuring Drive Gear Runout Using Dial Indicator
    G04876313Courtesy of NISSAN NORTH AMERICA, INC.
    • If the runout is outside of the limit, check the condition of the drive gear assembly. Foreign material may be caught between the drive gear and differential case, or the differential case or drive gear may be deformed.
      CAUTION: Replace drive gear and drive pinion as a set.
scientia non olet · About LEMON Manuals