Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Remove the drive shaft from the rear final drive assembly and support them using suitable wire. Refer to "REMOVAL AND INSTALLATION ".
CAUTION: Do not bend drive shaft joint to an excessive angle or excessively extend the slide joint.
Remove the side flange using Tools.
Tool numbers (A): KV40104100 (-)

(B): ST36230000 (J-25840-A)

Fig 1: Removing Side Flange Using Tool
Courtesy of NISSAN NORTH AMERICA, INC.
Remove the side oil seal using suitable tool.
CAUTION: Do not to damage gear carrier.

Fig 2: Removing Side Oil Seal Using Suitable Tool
Courtesy of NISSAN NORTH AMERICA, INC.