LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 911 (Rear Final Drive (R230)) >> Removal And Installation >> Carrier Cover >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a 3 mm (0.12 in) bead of sealant to the mating surface of the carrier cover as shown below.
    CAUTION: Remove any old sealant adhering to the mating surfaces. Also remove any moisture, oil, or foreign material adhering to the application and mating surfaces.
  2. Install the carrier cover to the gear carrier. Tighten the bolts to the specified torque. Refer to "DISASSEMBLY AND ASSEMBLY ".
  3. Install the rear final drive assembly. Refer to "REMOVAL AND INSTALLATION ".
    CAUTION: Fill the rear final drive assembly with recommended differential gear oil. Refer to DIFFERENTIAL GEAR OIL .
    Fig 1: Applying Sealant Bead To Mating Surface Of Carrier Cover
    G04901931Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals