Diagnosis Procedure
- CHECK TIRE
Check the following.
- Tire pressure
- Wear condition
- Longitudinal tire size (There is no difference between longitudinal tires.)
Are the inspection results normal?
YES: GO TO 2.
NO: Repair or replace damaged parts.
- CHECK 4WD WARNING LAMP
Stop the vehicle and allow it to idle for a short period of time.
Does flashing stop?
YES: Inspection End.
NO: GO TO 3.
- CHECK TRANSFER FLUID TEMPERATURE
Perform trouble diagnosis for transfer fluid temperature system. Refer to "DIAGNOSIS PROCEDURE ".
Are the inspection results normal?
YES: GO TO 4.
NO: Repair or replace damaged parts.
- SYMPTOM CHECK
Check again.
Are the inspection results normal?
YES: Inspection End.
NO: GO TO 5.
- CHECK TRANSFER CONTROL UNIT
Check transfer control unit input/output signal. Refer to "REFERENCE VALUE ".
Are the inspection results normal?
YES: Inspection End.
NO: Check transfer control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.