Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Apply ATF to the new O-ring and install it to the transfer motor.
CAUTION: Do not reuse O-ring.
Fit the double-flat end of the transfer motor shaft into the slot of the sub-oil pump assembly. Then tighten to the specified torque. Refer to "REMOVAL AND INSTALLATION ".
CAUTION: Be sure to install harness connector bracket.

Fig 1: Identifying ATF Applying Area On Transfer Motor
Courtesy of NISSAN NORTH AMERICA, INC.
Install the transfer motor air breather hose into the transfer motor (case connector) until the hose end reaches the end of the curved section. Set transfer motor air breather hose with paint mark facing leftward.

Fig 2: Identifying Paint Mark On Transfer Motor Air Breather Hose
Courtesy of NISSAN NORTH AMERICA, INC.
Connect the transfer motor harness connector.
Check the transfer fluid. Refer to "REPLACEMENT ".
Start the engine for one minute. Then stop the engine and recheck the transfer fluid. Refer to "INSPECTION ".