LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 910 (Transfer Case) >> Removal And Installation >> Transfer Control Unit >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set transfer state as 2WD when 4WD shift switch is at 2WD, or as AUTO when 4WD shift switch is at AUTO.
    CAUTION: When removing transfer control unit, transfer state must be at 2WD or AUTO.
  2. Turn the ignition switch OFF and disconnect negative battery terminal. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove the instrument lower panel RH and glove box. Refer to "REMOVAL AND INSTALLATION ".
  4. Disconnect the two transfer control unit harness connectors.
  5. Remove the transfer control unit bolts.
  6. Remove the transfer control unit.
    Fig 1: Locating Transfer Control Unit Bolts
    G04901583Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals