LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 910 (Transfer Case) >> Removal And Installation >> Transfer Control Device >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Change vehicle state to AUTO, and then remove and install transfer control device.
  1. Remove front propeller shaft. Refer to "UNIT REMOVAL AND INSTALLATION ".
  2. Disconnect the transfer control device harness connector.
  3. Remove transfer control lever.
  4. Disconnect vacuum line.
  5. Remove transfer control device.
scientia non olet · About LEMON Manuals