Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Install the new side oil seal until it is flush with the end face of case using Tool.
Tool number: ST22360002 (J-25679-01)
CAUTION:
- Do not reuse oil seal.
- Apply petroleum jelly to oil seal.
Install the transfer control device to the transfer assembly. Refer to "REMOVAL AND INSTALLATION ".
Install the companion flange. Refer to "DISASSEMBLY AND ASSEMBLY ".

Fig 1: Installing Side Oil Seal With End Face Of Case Using Tool
Courtesy of NISSAN NORTH AMERICA, INC.
Install the front propeller shaft. Refer to "UNIT REMOVAL AND INSTALLATION ".
Check for transfer fluid leaks. Check transfer fluid level and add specified fluid as necessary. Refer to "INSPECTION ".